Worcester Greenskies 300 Litre Cylinder
The Worcester Greenskies 300 Litre Cylinder is a stainless steel
unvented twin coil storage cylinder specifically designed to
be installed in conjunction with Worcester Greenskies solar
system. Should installation with an alternative solar system
be considered please seek guidance to ensure compatibility
prior to commencing installation.
The Worcester Greenskies 300 Litre Cylinder is not compatible in an installation
utilising two individual boilers.
The Greenskies solar cylinder is made from Duplex stainless
steel for excellent corrosion resistance. Greenskies
cylinders have a strong rust-proofed steel case and are well
insulated with environmentally friendly foam. It is available
in a range of 4 sizes from 180 - 300 litres.
The Worcester Greenskies 300 Litre Cylinderr is supplied complete with all the
necessary safety and control devices needed to connect to
the cold water mains. All are pre-adjusted. High quality
controls have been selected to combine high flow rate
performance with minimum pressure drop to make
Greenskies cylinders perform well in most areas.
Greenskies cylinders are WRAS approved to show
compliance with Building Regulations G3 and Part L.
Storage prior to installation
The Worcester Greenskies 300 Litre Cylinder should be stored in its original
packaging in an upright position in an area free from
excessive damp.
Dimensions (See Diagram Above)
Model |
300 |
A |
365 |
B |
420 |
C |
465 |
D |
1255 |
| E |
1200 |
| F |
1200 |
| Diameter |
550 |
Features
- Inlet control set (pressure reducing valve, strainer,
non-return valve and expansion relief valve).
- Temperature & pressure relief valve.
- 15mm/22mm Tundish.
- Expansion vessel 18 litre or expansion vessel 24 litre.
- Wall mounting bracket (for the expansion vessel).
- 22mm DZR compression connections.
- 1 x 15mm end feed tee.
|
|
- 2 x two port valves.
- Wiring centre.
- Pockets for thermostat points.
- 1 x dual thermostat and 1 x high limit thermostat.
- Greenskies cylinders are WRAS and BBA approved products to meet G3 Building Regulations.
- Expansion valve (to discharge).
- Expansion vessel hose.
- Immersion heater with thermostat and thermal cut out.
|
