Call us today until 10:00pm on 0203 113 2122We are open tomorrow at 7:00am

0
£0.00 Inc VAT

Timeswitches and Programmers

The following timeswitches and programmers are for use on heating only or heating and hot water appliances To control both hot water and heating on an appliance you will need a 2 channel programmer / timeswitch. To control only heating or only hot water you will need a single channel programmer / timeswitch. Generally a normal programmer would be used in conjunction with a room thermostat to control a heating zone or cylinder thermostat to control the hot water circuit, or on its own if no temperature control is required. A programmer works on the ON / OFF Principle.


Danfoss Randall TS715 SI Electronic Timeswitch
£54.78 RRP: £62.10
SAVE 12%
Danfoss Randall CP715SI Two-Channel Timebase Programmer
£66.40 RRP: £88.38
SAVE 25%
Danfoss Randall FP715 SI Two-Channel Full Programmer
£67.83 RRP: £95.18
SAVE 29%
Danfoss 103 Electro-Mechanical 24 Hour Time Clock
£74.46 RRP: £106.30
SAVE 30%
Danfoss Randall RX1 Single Channel Receiver Unit
£82.75 RRP: £111.65
SAVE 26%
Danfoss 102 Electro-Mechanical 24 Hour Programmer
£83.76 RRP: £119.57
Clearance
Danfoss Randall FP975 7 Day Full Programmer
£91.83 RRP: £128.12
SAVE 28%
Danfoss Randall RX2 Two Channel Receiver Unit
£95.34 RRP: £129.80
SAVE 27%
Danfoss 3020P Electro-Mechanical 24 Hour Programmer
£103.24 RRP: £144.60
SAVE 29%
Danfoss Randall 4033FRU Factory Replacement Programmer Module
£107.28 RRP: £150.30
SAVE 29%
Danfoss Randall RX3 Three Channel RF Receiver Unit
£108.99 RRP: £148.43
SAVE 27%
Recently viewed products
-