Delphi Loop Chrome 3-Hole Deck Mounted Bath Filler Tap

Delphi Loop Chrome 3-Hole Deck Mounted Bath Filler Tap

The spout on this bath filler reaches a full 180mm across the bath, so water lands well inside the tub rather than dribbling down the inner wall. It is the flat, blade-shaped spout the Loop range is built around, set on a low round body that stands only 135mm above the deck. Hot and cold sit on their own pillars either side, each with a small curved paddle lever that opens with a quarter turn.

The three pieces drop into standard three-hole bath tap centres and share the same chrome as the rest of the Loop collection.

Product Features

• Three hole deck mounted bath filler for a bath with a drilled tap ledge
• Flat blade spout reaching 180mm across the bath from a 135mm high body
• Independent hot and cold pillars, each with a curved paddle lever
• Polished chrome finish that sits comfortably in a modern white bathroom
• Quarter turn ceramic discs seal against each other, so no washers wear out
• Solid brass body weighing 2.71kg, built to take years of daily use
• Needs 2 bar or more, so a combi or unvented cylinder rather than a gravity tank
• Runs at 19.4 litres per minute at 2 bar, filling an average bath briskly
• Pairs with the Loop basin mixers if you are fitting out the whole room
• Guarantee: 5 years, with 12 months on serviceable moving parts